Axminster HBS350N, User Manual

Page: 9 / 36

Main Assembly
9
Hex bolts and washer (H), see fig 07. Locate the three
M8 square head bolts (F), three M8 nuts/washer (G)
and the fence guide rail (2). Introduce the square
head bolts into the pre-drilled holes to the front of
the table (1) and lightly screw on a washer and nut,
see fig 08. (NOTE: DO NOT TIGHTEN AT THIS POINT)
Fig 07
Fig 08
Step 3 Locate the fence guide rail (2), remove the
capping plate from the right side of the fence guide
rail by undoing the two Phillips screws and place
safely aside. Slot the square headed bolts (F) into the
guide rails “T” slot and slide on, see fig 09. Secure the
Fig 09
Fig 10
rail in place by tightening the three nuts beneath
the table, see fig 10. Replace the capping plate you
removed earlier, see fig 11.
Fig 11
Step 4 Locate the guide fence assembly (4), fit the
fence over the back rail first then lowering the front
clamp over the fence rail (2), see fig 12. Push down
the locking lever and check the fence clamps up
correctly, see fig 13.
Fig 12
Continues Over...
1
2
3
H
F
G
Guide rail “T” slot
Capping plate
4
2