CHANGING THE ABRASIVE BELT/DISC
14
5
6
4
The abrasive disc is attached to the sander’s face by Velcro,
a strip of fabric that clings when pressed together. Simply
peel off the old abrasive disc. Clean the surface of the disc.
Line up the new abrasive disc with the face of sanding disc
and using a piece of cloth in your hand or wear a glove, to
firmly press the abrasive to the disc plate, the application
will be reinforced by a gentle sanding action across the
face when you first use the new sanding disc. Re-assemble
the sander.
CONNECT THE SANDER TO THE
MAINS SUPPLY AND CONTINUE
WITH OPERATION.
Linisher Belt
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
1
Loosen the two clamping Hex screws holding the linisher
and raise to the vertical position. Tighten the Hex screws.
Remove the worktable (B) if installed for easy access and
place to one side.
2
3
