ASSEMBLY/SETUP & ADJUSTMENT
7
1
12
10
11
9
8
1.6mm clearance required
Loosen
caphead
screw
The gap between the table and the disc should be set to
a maximum of 1.6mm to clear the debris and to ensure
sufficient support for the timber.
The linisher can be raised to the vertical position to utilise
the worktable (B). See instruction below for setting up the
linisher.
Loosen the two clamping Hex screws holding the linisher in
the horizontal position and raise the linisher to the vertical
position.
Slide the mitre fence (D) onto the table, place a square
against the fence/disc and adjust until square. Reset the
pointer to ‘Zero’.
Check the table is level and adjust by loosening the
caphead screw as shown above.
Square
Pointer
D
Setting Up the Linisher
Continues Over...
