SETUP & ADJUSTMENT
9
6
2
1
3
4
5
Tracking the Linisher Belt
The tracking control works as follows:-
Using your hand, roll the belt towards the drive drum, check
that the belt stays in the middle of the table, if not, adjust
the track control slightly, and move the belt again, continue
until the belt runs down the centre of the linisher’s table
Turn the tracking wheel towards you to manoeuvre the belt to
the left.
Turn the tracking wheel away from you to manoeuvre the belt
to the right.
Belt tracking down the centre of the linisher
DO NOT make large adjustments,
and remember the belt may take
time to react to your alteration.
Little by little is a good maxim
to observe when carrying out
tracking operations.
Tracking
wheel
