Axminster Trade MJ12-1600 MKII, Manual

Page: 14 / 56

Initial Assembly
14
6. Raise the clamping handle on the control assembly (2)
and position the rip fence so its in line with the edge of
the main tables ‘T’ slot, push the handle down to lock in
place, see fig 32. If the fence is out of alignment loosen
Fig 32
the nuts holding the fence rail shaft (20), adjust the shaft
until the rip fence (21) is in alignment. Re-secure the rail
shaft, see 25-26 on previous page.
7. Locate the table joiner strengthener (5), remove the
nuts and washer from the joiner, line up the three
bolts, introduce them into the pre-drilled holes to the
opposite side of the extension tables (10-11). Replace
the washers and nuts and securely tighten, see fig 33-34.
Main tables ‘T’ slot
Sliding Table
You will require the following, the sliding table extension
support arm (1), sliding table assembly (19), sliding table
fence (23), sliding table Extension (13), mitre fence (3) for
sliding table, Workpiece clamp shaft (22) and Workpiece
support shoe (4).
1. Remove the four ‘T’ bolts/nuts and washers from the
angled support brackets on the main saw (0), place safely
aside, see fig 35-36.
Fig 33-34
5
Fig 35-36
NOTE: YOU WILL REQUIRE HELP FOR THIS
NEXT STEP!
2. With assistance lower the sliding table assembly (19)
onto the main saw (0), see fig 37. Retrieve the ‘T’ bolts/
nuts and washers, line up the ‘T’ slots to the ends of
the sliding table (19) with the slots in the angle
brackets, slide on the ‘T’ bolts, replace the washers/nuts
and securely tighten, see figs 38-39.
Fig 37
Fig 38-39
19
‘T’ slot
‘T’ bolt
‘T’ bolts washers and nuts
0
Angled support bracket