Axminster Trade G-800, Original Instructions Manual

Page: 18 / 36

16
5.1.3 Parameter and Mode Setting
1. Start/Stop Mode Interface
There are two start/stop modes of the machine.
The operation steps are as followings:
(1) Switch to the Start/Stop Mode Interface by pressing
, as shown in Fig. 10-2 .
 Manual start/stop mode.
 Intelligent linkage start/stop mode. In this mode, the dust source equipment should be
connected to the Synchronous Control. (See
5.3 Operation Instructions of the
Synchronous Control ).
(2) Press , move the cursor “>”to the desired mode.
(3) Press , the asterisk
“
*
”
will display in front of the desired mode indicating that the setting
is working now.
Fig.10-2
2. Running Mode Interface
The machine can run in Speed Adjustment mode or Flow Cruise mode. While in Speed
Adjustment mode, the speed can be adjusted by the
Knob D ( Fig. 9 ); while in Flow Cruise mode,
the power set by the user will not change.
The operation steps are as followings:
(1) Switch to the Running Mode Interface by pressing
, as shown in Fig. 10-3 .
 Speed
：
Speed Adjustment mode
 1760W
：
1200W Constant Power mode
 1980W
：
1350W Constant Power mode
 2200W
：
1500W Constant Power mode
 2420W
：
1575W Constant Power mode
(2) Press , move the cursor “>”to the desired parameter or mode.
(3) Press , the asterisk
“
*
”
will display in front of the desired parameter or mode indicating
that the setting is working now.
Note : After you complete the conversion of running mode, the new running mode will not work
until you reconnect the power.