Axminster Trade G-800, Original Instructions Manual

Page: 13 / 36

11
4.3.3 Connection
Use flexible hose or solid pipe to connect the inlet with the dust source.
Plastic pipe, such as Polypropylene or Polyvinyl Chloride, can be used as long as it’s been
determined and confirmed that the dust is not an explosion hazard.
This machine does not contain dust collection hose(s) due to the dust source differences.
4.3.4 Power Supply
Fig. 7
Wire the machine as indicated on the name plate.
Refer to the electricity diagram as shown in Fig. 2 if needed.
For the North American market, the equipment comes with 1.8 meters of cable with a plug
(6-20P) as Fig.7.
For the
European market, the machine is equipped with an industrial plug with European
Standard.
Grounding
As shown in Fig. 7, there is a grounding screw on the back side of the machine. This machine
should be connected to a permanent, grounded metal wiring system through this screw.
Electrical connections must be made by a qualified electrician in compliance with all
relevant building codes and ordinances.
Make sure the switch is in the “OFF” position before connecting to the power supply to
avoid an unexpected start.
This machine must be properly grounded to help prevent electrical shock and possible
fatal injury.
Repair or replace a damaged or worn cord immediately.
Using an extension or undersized cords will cause a drop in the line voltage and may
result in loss of power and possible overheating.