AXIS Q6055-S PTZ Network Camera
Specifications
Function
Wire
Connect to
Specifications
Digital input – I/O terminal connector
0 to max 30 V DC
Configurable (Input
or Output)
2 – blue
7 – yellow
Digital output – I/O terminal connector
0 to max 30 V DC, open
drain, 100 mA
RX+
3 – green/white
Ethernet – receiving
RX-
4 – green
Ethernet – receiving
TX+
5 – orange/white
Ethernet – transmitting
TX-
6 – orange
Ethernet – transmitting
0 V DC (-)
8 – black
0 V DC
DC output (24 V)
1, 9 – red
Power connector
24 V DC
Media converter switch connectors
NO
NO
NOTICE
TICE
TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’s
instructions. For information about regulatory requirements, see .
Important
The media converter switch does not support hotswapping. Disconnect power from the switch before swapping cameras. An
attempt to hotswap could cause the switch to freeze, in which case it must be restarted.
Camera connectors
Power connector
Two 2-pin terminal blocks for power output (pin 4 is not used).
Function
Pin
Notes
24 V DC
1, 2
Power out to camera
0 V DC (-)
3
DC output
N/A
4
N/A
Network connector
Two 2-pin Ethernet terminal blocks.
19
