Axis OfficeBasic USB Wireless G, User Manual, Page: 21 / 43

Print Server Management
AXIS OfficeBasic USB Wireless G 21
Wireless Status Mode: Displays the wireless operation mode of your print server.
AP’s MAC Address: Displays the MAC address of your wireless Access Point.
SSID: Displays the SSID of your wireless network.
Channel Number: Displays the current channel number.
Data Transmit Rate: Displays the current transmit rate: Auto or 1 - 54Mbps.
Transmit Mode: Displays the data transmission mode: b Only, g Only or Auto.
Signal Strength: Displays the strength of the Access Point signal.
Signal Quality: Displays the quality of the Access Point signal.
Authentication Type: Displays the authentication used: Open System, Shared
Key, WPA-PSK, WPA2-PSK.
Encryption: Displays the encryption used: None, WEP-64, WEP-128, WPA-
PSK(TKIP), WPA-PSK(CCMP), WPA2-PSK(TKIP), WPA2-PSK(CCMP).
TCP/IP Status Use DHCP/BOOTP: Displays DHCP/ BOOTP status. If there is a DHCP/BOOTP
server on your network, the print server can obtain IP settings automatically,
provided that this parameter is
On.
IP Address: Displays the IP address of the print server. The IP address must
meet the IP addressing requirements of the network segment.
Subnet Mask: Displays the subnet mask of the print server. The subnet mask
must meet the IP addressing requirements of the network segment.
Default router: Displays the default router used by the print server.
Rendezvous Settings: Displays if Rendezvous is enabled or disabled.
Service Name: Displays the print server’s Rendezvous service name.
AppleTalk Status AppleTalk: Displays if Appletalk is enabled or disabled.
AppleTalk Zone: If no zone exists, the zone name is displayed as an asterisk (*).
Port Name: AXxxxxxx_USB, where xxxxxx represent the last six digits of the
print server’s serial number, found on the print server’s label.
Type: Displays the printer type connected to the print server.
Binary protocol:
•
TBCP enables the print server to use the TBCP (Tagged Binary
Communication Protocol) to transfer print data to the printer.
•
BCP enables the print server to use the BCP (Binary Communications
Protocol) to transfer print data to the printer.
•
ASCII disables all binary transfers, select this alternative for all non-
PostScript printers and for ASCII PostScript printing.
SNMP Status SNMP Communities: Displays SNMP communities from the print server. There
are two communities
(SNMP Community 1, 2) that control messages from the