Axis AX-DPG, User And Technical Manual, Page: 9 / 20

☞
Remove the appliance from the packaging.
INSTALLATION OF THE APPLIANCES
☞
Remove all plastic adhesive film from parts before installing the
appliance. Clean parts thoroughly to remove all adhesive residue.(Do
not use abrasive substances)
GAS LEAKAGE CHECKING
☞
Before putting into service, ensure that there are no gas leakages from
the gas system of appliance. Brush soapy water over the unions and
couplings; leaks are detected by the appearance of bubbles.
WARNING: Never use open flames to detect gas leakages.
9/19
GAS PRESSURE CHECKING
☞
Measure gas pressure by means of a water type pressure gauge (e.g. a
U-type pressure gauge with 0.1 mbar minumum resolution).
• Remove the pressure gauge test point screw “A” on the inlet gas pipe
(fig.4)
• Connect the U-type pressure gauge.
• Read the gas pressure.
• Note: If the pressure value is not within the specified limits (see
technical specifications ), do not use the appliance under any
circumtances.Inform the gas supplying company immediately.
• After pressure checking, remove the pressure gauge and tighten the
screw with a correct seal.