Adding Printers in NetWare
42
AXIS 5400+ / AXIS 5600+ User’s Manual
Section 6
Adding Printers in NetWare
This section describes how to continue the installation of the AXIS
5400+/AXIS 5600+ in the NetWare environment. Identify which transport
protocol you are running on your network and which installation method
you should use. Continue the installation by selecting the appropriate
installing instructions from the table below:
See
“NetWare Administration”
on page 66 for information on Novell’s
administration tools.
If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-
protocol, mixed environment, you should also proceed to the other
relevant sections in this manual.
Installation
method
Transport
protocol
Action
NDPS
TCP/IP
IPX/SPX
See
“Setup using NDPS”
on page 43 and
“Public Access Printers”
on page 44
“Controlled Access Printers”
on page 48
iPrint
iPrint over LPR
See
“Setup using iPrint”
on page 57 and
“Install a printer using AXIS LPR Gateway Configuration Snap-in”
on page 59
iPrint over IPP
See
“Setup using iPrint”
on page 57 and
“Install a printer with AXIS IPP Gateway Configuration Snap-in”
on page 59
Queue-based
printing
IPX/SPX
Basic
Configuration
To install using the AXIS NetPilot Installation Wizard,
see
“Basic Setup with AXIS NetPilot”
on page 61
IPX/SPX
Advanced
configuration
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard, see
“Advanced Installation using AXIS NetPilot”
on page 62
