PESHEAT2V01
2016-01-08
38
Shortly pressing the button
will imitate flow pulses: V1 = 100000, V2 = 50000, V3 =
100000, V4 = 100000 (in volume units, displayed on LCD)
During the test, blinking label „TEST“will be displayed.
After the 100 s label “TEST” will stop blinking. Shortly pressing the button
you can read test
results.
8.5. Remote data reading
For data transmission from meter it can be used optical interface ( The optical head is placed on
the front panel of the calculator, as shown in fig.8.3 and is connected to RS-232 interface of reading
device) or any other wire serial interface, depending on the interface module is completed (see Table 7.3)
can be used.
Data collection from meters can be realised via PC, via telephone modem, via GSM modem, via
Internet, and so on.
The scheme of meter connection to the computer is presented in Annex B, Fig. F4. Modem or
printer connection scheme – in Annex B, Fig.B5.
Restriction of operating time (only for battery supply version):
-operating time after forced activation with any control button not more than 5 min.
-total time of sending and receiving data per month not more than 80 min (interface is blocked
after declime of time limit. It can be unblocked after forced activation with any control button not more
than for 5 min).
9. VERIFICATION
Metrological control of heat meter parameters is performed according to requirements defined in EN
1434-5.
10. TRANSPORTATION AND STORAGE REQUIREMENTS
Requirements for safe transportation and storage of temperature and pressure sensors are
provided in relevant technical documentation.
Packed equipment may be transported in any type of covered vehicle. Equipment should be
anchored reliably to avoid shock and possibility to shift inside vehicle.
Equipment should be protected against mechanical damage and shock.
Equipment should be stored in dry, heated premises, where environment temperature is not lower than +5
o
C. No agresive chemical substances should be stored together because of corrosion hazard.
11. WARRANTY
Manufacturer gives the warranty that equipment parameters will meet the technical requirements,
listed in the paragraph 2 of this document, if transportation, storage and operation conditions will be
followed.
Waranty period - 12 months from bringing into operation, but not more than 18 months from
manufacturing date.
Manufacturer’s address:
AB “Axis Industries ”, Kulautuvos g. 45a, Kaunas LT-47190, Lithuania
tel. +370 37 360234; fax. +370 37 360358.
