PESHEAT2V01
2016-01-08
34
Table 8
Symbol on the upper
part of display
(Zone C)
Measurement unit
(parameter symbol)
Zone E
Parameter
code
Zone A
Parameter value
Zone B
Σ
MWh (Gcal, GJ)
-
Total thermal energy E
1
MWh (Gcal, GJ)
-
Thermal energy component E1
2
MWh (Gcal, GJ)
-
Thermal energy component E3
1
t (m3)
-
Fluid mass (volume) M1 (V1)
2
t (m3)
-
Fluid mass (volume) M2 (V2)
-2
t (m3)
-
Reverse flow fluid mass (volume) -M2 (V2)
1-2
t (m
3
)
-
Fluid mass (volume) difference M1-M2 (V1-V2)
3
t (m3)
-
Fluid mass (volume) M3 (V3)
4
t (m3)
-
Fluid volume V4
1
o
C
-
Average (hourly, daily or monthly) temperature
1
2
o
C
-
Average (hourly, daily or monthly) temperature
2
3
o
C
-
Average (hourly, daily or monthly) temperature
3
1
kPa
-
Average (hourly, daily or monthly) pressure p1
2
kPa
Average (hourly, daily or monthly) pressure p2
1
Er:
Error code Er1 (total sum)
2
Er:
Error code Er2 (total sum)
h
Device run-time
h
A:
Operating hours (without energy calculation
error)
1-2
h
1:
Time, when temperature difference (
1-
2)<d
min
1
h
2:
Time, when flow rate q1<q1min
2
h
2:
Time, when flow rate q2<q2min
3
h
2:
Time, when flow rate q3<q3min
4
h
2:
Time, when flow rate q4<q4min
1
h
4:
Time, when flow rate q1>q1max
2
h
4:
Time, when flow rate q2>q2 max
3
h
4:
Time, when flow rate ai q3>q3 max
4
h
4:
Time, when flow rate q4>q4 max
2
h
8:
Failure time of flow measurement channel V2
3
h
8:
Failure time of flow sensor V3
4
h
8:
Failure time of flow sensor V4
To move to the next level - “PRN” - press and hold button
.
8.2.5. Printing reports (level 4)
Connect printer to calculator using external communication interface or optical communication
adapter. Printer serial port data transfer rate should be the same as defined in calculator settings. Printer
should be set to condensed printing mode.
For printing report via wire interface – in configuration parameter “20” – to set value “1”, for
printing via optical interface – to set value “2” (see table 7.1)
