AXIOMTEK SHB100, User Manual

Page: 53 / 68

SHB100
LGA775 SBC User’s Manual
PHOENIX-AWARD BIOS Utility 47
User Define: Allows you to set the power saving time in the
“ Suspend Mode “ and “ HDD
Power Down
“ fields.

Video Off Method
This setting determines the manner in which the monitor is blanked.
V/H
SYNC+Blank It turns OFF vertical and horizontal synchronization ports and writes blanks to the
video buffer.
DPMS Select this option if your monitor supports the Display Power Management Signaling
(DPMS) standard of the Video Electronics Standards Association (VESA). Use the
supplied software for your video subsystem to select video power management
values.
Blank Screen The System only writes blanks to the video buffer.
 Video Off In Suspend
This item defines if the video is powered down when the system is put into suspend mode.
 Suspend Type
If this item is set to the default Stop Grant, the CPU will go into Idle Mode during power saving
mode.
 Suspend Mode
After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU
shut off. The default value is
“Disabled”
.
Disabled System will never enter SUSPEND mode
1/2/4/6/8/10/
20/30/40
Min/1 Hr
Defines the continuous idle time before the system entering SUSPEND mode.
If any item defined in (J) is enabled & active, SUSPEND timer will be reloaded
 HDD Power Down
If HDD activity is not detected for the length of time specified in this field, the hard disk drive
will be powered down while all other devices remain active.
 Soft-Off by PWR-BTTN
This option only works with systems using an ATX power supply. It also allows users to define
which type of soft power OFF sequence the system will follow. The default value is
“Instant-Off”
.
Instant-Off This option follows the conventional manner of system performance when turning the
power to OFF. Instant-Off is a software power OFF sequence requiring the power
supply button is switched to OFF.
Delay 4 Sec.
Upon the system
’s turning OFF through the power switch, this option will delay the
complete system power OFF sequence approximately 4 seconds. Within this delay
period, the system will temporarily enter into the Suspend Mode enabling you to
restart the system at once.
 Wake-Up By PCI card
If this item is enable, it allows the system to resume from a software power down or power
saving mode whenever there is an
I
ncoming call to an installed fax/modem. This function needs to be supported by the relevant
hardware and software.