AXIOMTEK SHB100, User Manual

Page: 30 / 68

SHB100
LGA775 SBC User’s Manual
24 Hardware Installation
3.3 Installing the Memory
The board supports two 240-pin DDR2 DIMM memory sockets with maximum memory
capacity up to 4GB.
Please follow steps below to install the memory modules:
1.
Push down latches on each side of the DIMM socket.
2. Align the memory module with the socket that notches of memory module must match
the socket keys for a correct installation.
3. Install the memory module into the socket and push it firmly down until it is fully seated.
The socket latches are levered upwards and clipped on to the edges of the DIMM.
4. Install any remaining DIMM modules.
3.4 Installing the Backplane
3.4.1 Notice for SHB100
SHB100 belongs to newer architecture for Single Board computer. So you need to use
PICMG1.3 Backplane (FAB100) this.(SHB100 could not compatible with original
backplane)