RTP120 All-in-One 12.1” TFT LCD Panel PC User’s Manual
Hardware Installation
15
C h a p t e r 3
Hardware Installation
This chapter describes the installation and the cable connection to the
system connectors. See system board User’s Manual that came with
your PANEL PC packaging for more details. Sections in this chapter
includes:
CPU
DRAM
HDD
3 x Serial Ports
Parallel Port
VGA
Ethernet
Keyboard
PS/2 Mouse
Cash Drawer(610e only)
Dallas Key(option)
Expansion Slot
System O/S and Software Installation
The RTP120 series has either a Pentium or a Pentium III/Celeron little
board with a free PCI slot inside and a 3.5” HDD drive bay. These
come as standard configuration of the system. Upgrading to a higher
performance CPU, higher capacity DRAM modules and hard disk
drive can increase system performance. The user can use the I/O
ports located at the bottom layer of the chassis to connect external
peripheral devices, such as a monitor, serial devices, parallel
printer…etc.
If you encounter difficulties during connection, loosen the screws on
the cable management shroud, then remove the shroud for easy
peripheral connection.
NOTE:
Make sure the power cord is disconnected before any
installation. To install any internal device such as CPU, DRAM
and HDD, take out the plastic rear cover and unscrew the
metal rear bracket first.
Summary of Contents for RTP120
Page 1: ...RTP120 All in One 12 1 TFT LCD Panel PC User s Manual...
Page 8: ...viii This page does not contain any information...
Page 13: ...RTP120 All in One 12 1 TFT LCD Panel PC User s Manual Introduction 5 1 4 Dimensions...
Page 25: ...RTP120 All in One 12 1 TFT LCD Panel PC User s Manual Hardware Installation 17...