2021-08-01 | Technical improvements, changes in design, printing- and other errors reserved.
21
4.1.3.
Bit error rate
The BIT ERROR RATE is shown. The amount of bit errors for the last 1,000,000 transferred bits is calculated.
4.1.4.
Found programs
After a successful station scanning, the radio and TV stations are shown in the area FOUND PROGRAMS. The
table contains information about the Program Name, the Type and the Encryption.
4.1.5.
Deactivating a tuner
If a tuner is not needed, it can be deactivated. The tuner then no longer searches for stations. In phase 2 and in
the station list, which can be printed as PDF, no programs are displayed for the tuner.
è
Click TUNER 1…8/16 to select one tuner.
The
Tuner enabled
check box is set at the factory.
è
To deactivate a tuner, deselect the
Tuner enabled
check box.
è
Then click SAVE AND SCAN.
This deactivates the tuner.
4.2.
Initialization - phase 2
è
Click on PHASE 2, to select programs.
The found programs are subdivided by tuner. After the station scanning in initialization phase 1 no programms
are activated.
In the
Modulator
column there are colored buttons M1 to M8 resp. M16. The buttons correspond to the
modulators of the headend. By clicking on the respective buttons in the tables, programs can be activated or
deactivated again.
You can assign programs to modulators in REMUX MODE or in CROSS MULTIPLEX MODE.
Important:
è
After you have made any changes, click on SAVE CHANGES.
Only then will the changes be saved and actually applied.
The more programs you assign to a modulator, the higher its data rate. When saving, the fill levels of the
modulators are therefore displayed.
