Operation Instructions | EoC 20-01 | Ethernet over Coax | Master
4
2021-03-17 | Technical improvements, changes in design, printing- and other errors reserved.
Observe the safety instructions supplied with the device! They are also available at the following Internet
address:
https://download.axing.com/BAs/Sicherheitshinweise_9sprachig.pdf
Use the device only as described in these operating instructions and in particular in accordance with the
state of the art. If the device is used for other purposes, no warranty will be assumed!
Declaration of Conformity:
Hereby AXING AG declares that the marked products comply with the valid guidelines.
EOC 30-02
: Hereby AXING AG declares that the device is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: https://axing.com/en/ce.
WEEE Nr. DE26869279 | Electrical and electronic components must not be disposed of
as residual waste, it must be disposed of separately.
STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
