3: T
he x
Sw
itc
h i
n d
ep
th •
9
• Port status page – shows status of the two 1000bt
ports (copper and SFP), the four PoE ports, and the
four 100bt ports. From this page, the user can iden-
tify which ports are active, the link speed, PoE active,
and which port is an uplink port.
»
Ports blinking indicate an active port.
»
1 dot next to a port indicates 10bt, 2 dots next to
port indicate 100bt, and 3 dots next to port indi-
cate 1000bt.
»
A bar above or below a port indicates active PoE
on that port. The amount of power through the
port is represented by the size of the bar.
»
An arrow pointing away from port indicates an
uplink port.
• PoE status page – shows the wattage applied to each
of the four (4) PoE ports. The xSwitch’s operating
temperature is also displayed.
• Node-ID page – shows the ID of the device and per-
mits the editing of this value with a 10 second press
of the ‘pencil’ (bottom) button. The IP address is also
shown.
• IP address page – shows the IP address of the device
and the netmask. Pressing the pencil (bottom) button
for 10 seconds allows manual editing of the IP ad-
dress from the front panel.
Switch details
The xSwitch supports 4 QoS queues. Highest priority
given to CoS 6 and 7. DCSP priority also recognized.
IGMP version 2 supported. IGMP snooping query
function is enabled with 10 second response time for
general queries. The xSwitch will relingish the query
function if a multicast router or another querier at a low-
er IP address is detected. The xSwitch has a 200 second
time out for router presence. If another querier is not de-
tected within the time out period, the xSwitch delegates
itself as a querier.
The xSwitch has two 1-gigabit ports. A port is either
the 1000BT copper interface or the SFP interface. If both
interfaces of the port are connected, the first detected
will be the active interface. The active interface is used
until the link goes down. In such a case, the second in-
terface becomes active for the port.
The SFP interface accepts fiber or copper modules.
In case of the copper SFP module, only 1GBit/s speed
is supported.
The xSwitch supports a single VLAN.
The xSwitch has a hardware filter capacity of 8k.
This is a single capacity for both MAC addresses and
multicast groups. The amount of either can vary between
network, but in any case, the xSwitch can manage any
amount of multicast groups connected to its 10 ports.
©2013 Axia Audio
