MV500V SERIES (
VER. STD 0.6)
16
CONNECTING AND CONFIGURING YOUR MODEM
Each Modem is factory built for use with a particular service provider. Thus, each
Modem is set to use particular radio channels and to enable services specific to a
provider.
Once your Modem has been activated with the network, connect your computer to
the Modem using the provided Ethernet (RJ-45) cable. You are now ready to use
the Internet.
Step 1
│
Setting Up the Hardware
1.1 Make sure your Modem is not connected to any power source and all LEDs
are OFF.
1.2 How to setup the Antennas for maximized performance:
①
CDMA antennas are located on both sides of the Modem.
②
Pull both antennas out until you hear clicking.
Antennas can be broken if you do not pull them out until clicking and if you try to force them up.
③
Make sure the antennas are upright as shown in picture 4 above. (vertically upright position)
④
Antennas rotate up to 90 degrees vertically and horizontally.
Antennas can be broken if you force them to more than 90 degrees from upright position.
1.3
Locate the CAT-5 Ethernet cable that is included with your Modem. Plug
one end of this cable into ANY Ethernet port on your Modem. Plug the other
end of the cable into the networking port on your computer.
1.4
Locate the power supply that is included with your Modem. Plug the power
supply’s small connector into the power port on the Modem. Plug the power
Summary of Contents for MV510
Page 1: ......
Page 56: ...MV500V SERIES VER STD 0 6 55...
