Axel BoxTel MKII, User Manual, Page: 40 / 47

BOXTEL MKII GSM
– GATEWAY GSM
| BOXTEL MKII GSM
– GATEWAY GSM
40
15
BOXTEL MKII GSM – GATEWAY GSM
Before you do the following function settings, Lift handset or press hands free key of telephone set, then you can press
the buttons according to the following instructions to finish setting, you will hear 2 beeps when you finish, this testify
setting successfully.
1) Restore to factory default setting
*#99#99# restore to factory default setting.
2) Adjust dial interval
*#01#30# , 01--command
，
30--time
，
Max 9.9 seconds
，
Min 0.5 seconds, default setting is 3
seconds.
*If you use GSM FWT-8848 for connecting to VoIP gateway, you can set dial interval as 0.5
second, it can make PDD<5 sec (Method: *#01#05#);
*If you use GSM FWT-8848 for connecting telephone, PBX, billing device, you can set dial
interval as 3 seconds or 5 seconds as you like (Method: *#01#30#, set the dial interval as 3
seconds).
3) Adjust Earphone Volume
*#02#15# 02--command
，
15--volume
，
Max 16
，
Min 1, default setting is 15.
4) Adjust Mic. Volume (sensitivity)
*#03#10# 03--command
，
10--amount
，
Max 16
，
Min 1, default setting is 10.
5) Setting local area code
*#04#*0755# 10--command
，
*0755
—area code ，
Max 5 numbers, use "*" instead if area code
is less than 5 digits.
6
）
Hide Caller ID (been sent out)Setting
*#13#01# 13--command
，
01--value
，
Max-02
，
Min-00 Default setting is 00
00-- presentation indicator is used according to the subscription of the CLIR service
01
– CLIR allowed
02
– CLIR prohibited
Notice: This Setting need GSM carrier support.
8) Bar incoming call Setting
*#14#00# 14--command
，
00--value
，
00--no barring, 01--set barring default setting --00
9)FSK setting (optional) (should confirm before order)
*#17#00# setting caller ID 17-order, 00-value, 00-DTMF, 01-FSK, default setting is 00 This setting need terminal has
FSK Chip set support
10) Billing Mode setting
*#15#00#
15--command, 00-value, 01-reversal polarity, 02-12 KHz, 03-16 KHz, default setting-- 01
11
）
IMEI change Setting ( for Quad Band M10 and SIM540W modules only)
1. Write IMEI to RAM
*#18#IMEI no.#, 18--command, IMEI No. --15-digits/numbers IMEI no.
2. Check IMEI, if it is right, and then write it to module.
*#19#IMEI no.#, 19--command, IMEI No. --15-digits/numbers IMEI No.
Notice: Step 1 and Step 2, IMEI no. must be same.