- Cold temp. sensing failure (Er / S1)
- Room temp. sensing failure (Er / S2)
- Fan motor failure (Er / Fn)
- Control board failure (Er / Cn)
- Pump failure (Er / BP)
Generating water indicator
- Dropping motion becomes active : Unit is now generating water
- Icon is in hold motion : Unit is in pause cycle
See Menu/Set button function
Water level indicator
- Shows level of water in top tank.
- If water level sensor is incorrect, text will start blinking and bars light
up intermittently
Refresh indicator
- Icons rotating clockwise : Unit is in re-circulation cycle.
U.V indicator
- Replacement of U.V indicated by red text light.
install new U.V and reset the U.V indication function by the Menu/Set
button (see page 13). Yellow light text will appear
- If both the U.V icon and U.V text blink : Check if U.V. light or ballast
has a problem
Self-Error detection function
In case of error during operation, 2 digits on the temperature/humidity
indicator show ERROR signals respectively. Turn off and unplug unit.
Wait a few seconds and Plug In and Turn On again. If the ERROR
signal continues to light up, turn unit off and call the Service Center
- No icon showing : Water generating function is disabled.
Notes : Proper UV function is essential to keeping the water clean and pure. If both the
icon and text are blinking continuously, call the Service Center immediately.
