1.
Check “Enable” check box to activate motion-based alarms. If unchecked, the
camera will not send out any signals to trigger motion-based recording to the
NVR or CMS, even if there is motion in the video.
Alarm Out:
If selected, this would trigger an external relay output that is
connected to the camera on detecting a motion-based alarm. (For the models
with two alarm output interfaces, two alarm output can be selected.)
Trigger Snap:
If selected, the system will capture images on motion detection and
save the images on an SD card.
Trigger SD Recording:
If selected, video will be recorded on an SD card on motion
detection.
Trigger Email:
If “Trigger Email” and “Attach Picture” are checked (email address
must be set first in the Email configuration interface), the captured pictures and
triggered event will be sent into those addresses.
Trigger FTP:
If “Trigger FTP” and “Attach Picture” are checked, the captured
pictures will be sent into FTP server address. Please refer to FTP configuration
chapter for more details.
2.
Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab
to
go to the interface as shown below.
