PUSH VIDEO CONFIGURATION
70
APPENDIX 7 PUSH VIDEO CONFIGURATION
A7.1 Alarm Sensor Connection
Connect the alarm sensor, such as magnetic contacts, to the alarm-in port on the NVR rear panel. Alarm-in 1
corresponds to video channel 1, alarm-in 2 corresponds to video channel 2, and so on.
Note:
The voltage restriction for alarm-in device connection is under DC24V 1A.
A7.2 Configuration
Before configuring Push Video, make sure:
1. The system is set up as described in “2. CONNECTION” at page 2.
2. This device is connected to Internet.
3. You’ve installed the app, EagleEyes, on your iOS or Android mobile devices.
For details, please refer to “8.2 Mobile Devices” at page 50.
Step1: Right click to show the main menu.
Go to
(ADVANCED CONFIG.)
NOTIFY
. In
PUSH VIDEO
, select the alarm device you want, and
configure the alarm type. For details, please refer to “PUSH VIDEO” at page 41.
ADVANCED CONFIG
CONNECTION
PUSH
VIDEO PUSH STATUS MESSAGE MAIL
VIDEO MAIL VIDEO FTP
CAMERA
RESET ALL GUARD CONNECTION
SUBMIT
DETECTION
ALARM TRIGGERED DEVICE
ALARM IN 1
ALERT
CH01
ALARM OFF / INTERNAL ALARM
CH1
NETWORK
CH02
ALARM
OFF
CH2
DISPLAY
CH03
ALARM
N.O.
office
RECORD
CH04
ALARM
OFF
CH4
NOTIFY
MULTICASTING
JOYSTICK
EXIT
Step2: Open EagleEyes, and add this device to the EagleEyes address book.
Step3: Enable Push Video as described below, and try to trigger your sensor to see if you can receive Push Video
successfully.
