Avtech AVC794, Installation Manual

Page: 11 / 26

6
3) In “CONNECTION”, it shows the examining result for DCCS signal transmission between the DVR and
camera. The message is as follows:
MESSAGE SHOWN MEANING
CHECKING The DVR is checking the DCCS signal transmission between the DVR
and camera.
OK The signal transmission is fine and the DCCS function works properly.
FAIL The signal transmission is too weak or not available for the DCCS
function to work properly.
2.10 Configuring DCCS Camera
DCCS cameras have three types: PTZ cameras, zoom lens control cameras, and human detection cameras.
Based on the camera type, different camera settings are needed as described below.
Note: iPhone Push Notification is available only when a human detection camera is connected properly
to the correct channel which supports DCCS. For iPhone Push Notification to work properly, please
refer to “APPENDIX 1. SET IPHONE PUSH NOTIFICATION” at page 15.
2.10.1 For a PTZ camera
Switch to the channel which connects to your PTZ camera, and click “ ” on the quick menu bar to
display the PTZ control panel.
Configure the camera by clicking “ ”. For camera configuration details, please refer to its user manual.
2.10.2 For a zoom lens control camera
In the “DCCS” menu, move to the channel which connects to the zoom lens control camera, and click
“SETUP” in “MENU”.
ADVANCED CONFIG
CANERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
W X
DETECTION DIAGNOSTIC START
ALERT
MENU SETUP
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
DEVICE AVK523
IVS
CONNECTION OK
NOTIFY
EXIT
Different zoom lens control cameras might have different parameter settings. For details, please refer to
their own user manuals.