AVPro Edge AC-MX-44HDBT, User Manual

Page: 43 / 57

43
IR NOTES (On the Matrix):
1. By default the IR IN is routed to the corresponding HDBaseT Output number (ie. IR IN #1 --> HDBaseT
Output 1, IR IN #2 --> HDBaseT Output 2, etc...)
2. By default the IR OUT is automatically routed with the active source (ie. If you are watching INPUT 3
on HDBaseT OUTPUT 1, when you point a remote at an IR Receiver on the HDBaseT Rx connected the
signal will be routed to IR OUT 3)
3. Each IR IN can be routed in any way you like (One to one or one to many) by using the command SET
IRC EXT SW x1.x2.x3.x4 (See below).
4. Each IR OUT can be routed manually as well using the command SET IRC OUTx VS INy. This can also
be controlled by the Web Interface
IR NOTES (On the HDBaseT Receiver):
1. IR OUT = IR Emitter for sending signals to a Display or Projector (Note - Use Provided Emitters)
2. IR IN = For sending IR signals back to the Matrix for switching AND to send IR signals to the IR OUT
on the Matrix - by default the IR OUT on the matrix is automatically routed with the active source (ie.
If you are watching INPUT 3 on HDBaseT OUTPUT 1, when you point a remote at an IR Receiver on the
HDBaseT Rx connected the signal will be routed to IR OUT 3)
IR Continued:
Direct connection to a control system - Set the switch to “I-PASS” to connect directly to a control system.
TIP - Signal
Sleeve - Ground
TIP - Signal
Sleeve - Ground
Control4 Wiring
Example