4. If the settings are correct, click
Up g rad e
.
To set the USB speed:
NOTE: This section only applies to the USB2 IQ adaptor.
1. From the side navigation bar, click
Ports - IQ ad ap tors
to open the IQ adaptors window.
2. Select the checkboxes next to the IQ adaptors that you wish to modify.
4.12 Launching a Session
NOTE: Java 1.6.0_11 or later is required to launch a session.
To launch a session:
1. From the side navigation bar, select Target Devices. A list of available devices appears.
2. The applicable action, KVM Session, is displayed in the Action column and depends on the
target device that was selected to launch the session. If more than one action is available for a
given target device, click the drop-down arrow and select the applicable action from the list.
If the target device is currently in use, you can be able to gain access by forcing a connection to the
device if your preemption level is equal to or higher than the current user's.
To switch to the active session from the local UI (local users only):
1. From the side navigation bar, select
Local S ession
.
2. Select the Resume Active Session checkbox. The Video Viewer window appears.
NOTE: The RAK-key is required for KVM remote access. RAK-key installation is only applicable for the
2108/2216 switch models.
NOTE: From the Active Sessions window, you can view a list of active sessions. The following
information is listed about each session: target device, owner, remote host, duration and type.
4.12.1 General sessions settings
To configure general session settings:
1. From the side navigation bar, select
S ession s - Gen eral
. The General Session Settings window
appears.
2. Select or deselect the
En ab le In activity T im eou t
checkbox.
3. In the Inactivity Timeout field, enter the amount of inactive time you want to pass before the
session closes (from 1 to 90 minutes).
4. In the Login Timeout field, enter the amount of inactive time you want to pass before you must
log in again (from 21 to 120 seconds).
5. Click
S ave
.
4.12.2 Local user account settings
NOTE: User Account settings are supported when the RAK-key is installed. RAK-key installation is
only applicable for the 2108/2216 switch models.
The OBWI provides local and login security through administrator-defined user accounts. By selecting
User Accou n ts
on the side navigation bar, administrators can add and delete users, define user
preemption and access levels and change passwords.
Vertiv
| Avocent® AutoView™ 2108/2216/3108/3216 Switch Installer/User Guide |
35
