2. Specify the events that generate notifications by clicking the appropriate checkboxes in the
list.
-or-
Select or clear the checkbox next to
Even t N am e
to select or deselect the entire list.
3. Click
S ave
.
4.10 Setting Event Destinations
You can configure audit events to be sent to SNMP trap destinations and Syslog devices. The events
enabled on the Events window are sent to all the devices listed on the Event Destination window.
To set event destinations:
1. Click
Au d itin g
and the Destinations tab to open the Event Destinations window.
2. Type the address of up to four management workstations to which this switch sends events in
the SNMP Trap Destination fields, as well as up to four Syslog devices.
3. Click
S ave
.
4.11 Ports Settings - Configuring an IQ Adaptor
From the switch you can display a list of the attached IQ adaptors, as well as the following information
about each IQ adaptor: EID, Port, Status, Application Version and Interface Type. You can click on one of
the IQ adaptors to view the following additional information: Switch Type, Boot Version, Application
Version, Hardware Version, FPGA Version, Version Available and Upgrade Status.
You can also delete an offline IQ adaptor and upgrade the IQ adaptor firmware.
4.11.1 Deleting IQ adaptors
To delete an offline IQ adaptor:
1. From the side navigation bar, click
Ports - IQ ad ap tors
to open the IQ adaptor window.
2. Click in the applicable IQ adaptor checkbox.
3. Click
Delete O fflin e
.
4.11.2 Upgrading IQ adaptors
The IQ adaptors automatically update when the switch is updated. To update your switch firmware, see
Tools - Rebooting and Upgrading
on page 30 or the DSView management software Online Help. If issues
occur during the normal upgrade process, IQ adaptors can also be force-upgraded when needed.
NOTE: Check http://www.VertivCo.com/en-us/support/ for firmware upgrade files.
CAUTION: Disconnecting an IQ adaptor during a firmware update or cycling power to the
device renders the module inoperable and require the IQ adaptor to be returned to the factory
for repair.
To upgrade the IQ adaptor firmware:
1. From the side navigation bar, click
Ports - IQ ad ap tors
to open the IQ adaptors window.
2. Select the checkboxes next to the IQ adaptors that you wish to modify.
3. Select
Ch oose an op eration
and select
Up g rad e
.
Vertiv
| Avocent® AutoView™ 2108/2216/3108/3216 Switch Installer/User Guide |
34