Avocent AMX 5030, Installer/User Manual, Page: 114 / 248

102
AMX Switch Series Installer/User Guide
Command Function
enable rerequest pod
Enables this mode. The user station will then attempt to request the pod channel if it
has been connected to a target and does not have the pod channel. The user station
will make one request approximately every 10 seconds. The request will only be
successful if the pod channel has been unused for the previous second.
disable rerequest pod Disables this mode. This cannot be done via the OSD if no switch is connected.
vcm sdb on
Turns On VCM Config access.
NOTE: Turning on VCM Config access must be done before using the commands
below. The default setting is Off.
vcm sdb off Turns off VCM Config access.
vcm cu
Tunes VCM (all three: red, green and blue) up 1 (setting is applied to current
connection only).
vcm cd Tunes VCM down 1.
vcm rcu Tunes red VCM up 1.
vcm rcd Tunes red VCM down 1.
vcm gcu Tunes green VCM up 1.
vcm gcd Tunes green VCM down 1.
vcm bcu Tunes blue VCM up 1.
vcm bcd Tunes blue VCM down 1.
vcm reset Resets VCM.
sk off Turns skew off.
sk apply Applies skew.
Table F.1: Access Commands (Continued)
AMX.book Page 102 Thursday, June 12, 2008 4:14 PM