Page 35
2. In the left-hand panel, scroll down to the
output
nodes and drag and drop the
ibmiot
node onto
Flow 1
. Position the node to the right and above the
safe
node.
3. Click the bubble on the
right
side of the
safe
node and with the left mouse button
pressed, drag the cursor over to the
left
bubble on your new
IBM IoT
node to make a
connection between them. Repeat the connection using the right bubble on the
danger
node.
4. Double-click the
temp thresh
node. Update the values in both boxes to
2500
(integer
representation of 25 degrees Celsius to two decimal places). Click the
OK
button.
5. Double-click the danger node. Add 10 spaces after critical as shown below. This will
correct an overwrite issue on the output console when switching between the
safe
and
danger
nodes. Click the
OK
button.
6. Double-click the new
IBM IoT
node to open its properties. Fill the parameters as shown,
but substitute your own
Device Type
and
Device ID
for the example values:
Summary of Contents for MicroZed 7010
Page 17: ...Page 17 ...
