Getti ng star ted
4
OVATION MA / SA 8.3
Fig. 5. Pin assignment of 3,5 mm trigger input (12)
1.3 Installation and cooling
The unit can become hot depending on the demanded output
power or environmental temperature. Therefore, it is import-
ant, that the cooling air can flow unhindered into the air inlets
in the bottom and flow out through the holes in the rear panel.
Set up the power amplifiers so that there is at least 10 cm
distance around the device to adjacent components or walls.
When placing the amplifier on a carpet, make sure that the
feet of the unit do not sink in (if necessary, underlay pucks)
and that the carpet pile does not seal the air slots in the floor.
Direct exposure to sunlight is not recommended because this
will heat up the unit and may cause unwanted malfunctions.
ℹ
NOTE
The installed transformers emit magnetic stray fields. To
prevent interference, it is recommended to not place the
unit(s) either directly on or near a preamplifier or a record
player.
a) Ground (GND)
b) Triggervsignal (+5V to +20V)
