38
5 INSTALLATION
Note: A Digital TV Antenna is used to connect to the
Terrestrial Receiver. The Antenna should
be used where the user is within an area with Digital Terrestrial TV coverage but the premises in which
the user intends to use the Receiver has not yet been upgraded with Digital Terrestrial TV receiving
capability. (Please refer to “Installation” for details.)
If you do not know whether the building
concerned has been upgraded with Digital Terrestrial TV receiving capability, you may make relevant
enquiries with your building management.
Please connect the Receiver to your television set (HDMI cable recommended) and connect the
antenna to the “ANT IN” input connector on the Receiver. Connect one end of the IEC Power Cable to
the Receiver and the other end to power supply. Switch on your TV set and the Receiver.
When the welcome screen is displayed, please select the preferred language for the user interface and
the country where the Receiver is used by pressing LEFT/RIGHT key
.
Set the antenna supply as ON to
feed the DC5V to the antenna if it is necessary. Place the cursor to the Installation item by pressing
DOWN key and press OK key to the next step.
If you decide to use the Flat Panel Antenna, please turn ‘On’ the Antenna Power.
The channel search page will display on the screen and then you can select manual search or auto
search by press LEFT/RIGHT key.
The Receiver will start to search for available channels and will take a few minutes to complete the
process. When a TV channel is detected, its corresponding Signal strength and Signal quality will be
