Jump to: Table of Content
2022/04/11
Page : 20
5.4.5
Using the WAGO connector
To open the WAGO clamp, insert a screwdriver as shown in the picture
to the left. Push down gently
–
this will open the clamp and you can
insert the cable.
Typically, WAGO clamp is included in the scope of delivery.
Type of connector: WAGO 734
5.4.6
WAGO to D-Sub Adapter
There is a WAGO to D-Sub adapter available (product #
“
Z3011
”)
.
This adapter allows for easy cable connection from standard RS232
cable to WAGO, including a power supply with a barrel connector.
Barrel connector for power supply: The matching plug has the
following dimensions (which are widely used and very much a
‘standard’):
Diameter outside: 5.5 mm, inside: 2.1 mm and a shaft
of 9.5 mm. Polarity: middle pin is + voltage, outside is ground (-)
voltage. Same voltage as described above.
Please note: For the Avisaro 4.0 family with 2x RS232 WAGO: only one of those connectors fit
–
two
connectors are to wide !
5.4.7
1x RS232 “SILVER” ( “M41076”, “C41076” )
Connector
Interface
Pin
Signal
Direction
Screw Type
1
st
RS232
1
GND
Power & Signal
