Avisaro 4.0 Series, User Manual

Page: 26 / 46

Jump to: Table of Content
2022/04/11
Page : 26
Cables are connected with the WAGO 734 series connectors. In most product configurations, those
adapters are shipped with the box. Check the 'scope of delivery' list.
5.6.7 Using the WAGO connector
To open the WAGO clamp, insert a screwdriver as shown in the picture
to the left. Push down gently
– this will open the clamp and you can
insert the cable.
Typically, WAGO clamp is included in the scope of delivery.
Type of connector: WAGO 734
5.6.8 WAGO to D-Sub Adapter
There is a WAGO to D-Sub adapter available (product # “ Z3012 ”) .
This adapter allows for easy cable connection from standard CAN
cable to WAGO, including a power supply with a barrel connector.
Barrel connector for power supply: The matching plug has the
following dimensions (which are widely used and very much a
‘standard’): Diameter outside: 5.5 mm, inside: 2.1 mm and a shaft
of 9.5 mm. Polarity: middle pin is + voltage, outside is ground (-)
voltage. Same voltage as described above.
Please note: For the Avisaro 4.0 family with 2x CAN WAGO: only one of those connectors fit – two
connectors are to wide !
5.6.9 1x CAN “SILVER” ( “M4 3 076”, “C4 3 076” )