Avidyne FlightMax EX500, Pilot'S Manual, Page: 116 / 184

Datalink (Optional)
Avidyne EX500/EX600 MFD -104- 600-00078-001 Rev 05
■
Datalink Radar Resolution - High
■
DL RDR Resolution - High
■
Request Interval - High Rate
■
Text METARS - ON
■
METAR Symbols - ON
■ TAFs - ON
■
Lightning - ON (Release 4.1 and later)
■
AIR/SIGMETS (USA Only) - OFF
■
TFRs (USA Only) - OFF
■
Winds & Temps - ON (Release 4.1 and later)
■
Sat IR - ON (Release 4.1 and later)
● Next DL Page - Opens the Message Center page.
●
Select - Scrolls through fields and selects a field to edit. Rotate
the Change knob to change the setting in the selected field.
● Save - Saves the current settings. The new saved settings are
sent to the NOC and the stream of data being sent to the aircraft
will be affected from that point forward.
●
Cancel - Cancels changes made to this page and returns the
settings to the previous settings. Pressing Cancel cannot undo
Saved changes.
The Datalink Setup page contains the following fields:
●
Narrowcast Enabled or Multilink Enabled - Enables Iridium 2-
Way Datalink. Check this box if an MLX770 Iridium Transceiver is
installed in the aircraft. If Broadcast is enabled, Multilink Enabled
is shown, otherwise Narrowcast Enabled will be shown.
●
Coverage Area - Specifies the type of coverage being
requested: (Also see Optimizing MultiLink for ORBCOMM
(Release 4.0 and earlier) on page 116)
■ Flight Plan - Requests weather information for a corridor
along the entire current flight plan, with the specified
Coverage Radius to either side of the flight plan route. The
boundary of the datalink radar coverage area is shown by an
outline with diagonal stripes.