EX5000 Installation Manual
P/N 600-00073 Rev 24
- 25 -
4.7 Wiring External Devices
4.7.1 GPS and FMS Wiring
GPS data may be received via a GAMA 429 Graphics interface or a RS-232 interface. See the
appropriate wiring diagram and the specific installation instructions for your particular GPS. For more
information, see Section 5.5, “GPS/FMS Navigators Setup” on page 35.
Note:
For the EX5000, Avidyne recommends using an GAMA 429 Graphics connection for FMS/
GPS. The GAMA 429 Graphics input can contain heading data, necessary for overlay
capabilities as well as approach procedures and the display of curved segments. For more
information, see Section 5.5.1, “GAMA 429 Graphics Setup” on page 35.
4.7.2 Dual GPS Setup with GAMA 429
The EX5000 can receive information from two GAMA 429 Graphics capable GPS units. Connect the
GPS according to the wiring diagram in Appendix J:
.
Select a different ARINC port for GPS 2.
4.7.3 Broadcast Datalink Receiver Wiring
See the wiring diagram in Appendix K:
Wiring Diagram – Lightning, Datalink Sensors, and ORBCOMM
and the
HeadsUp XMD076 Installation Manual
. Connect the RS-232 port of the Datalink
receiver to any of the available RS-232 ports of the MFD as shown. (RS232 #4 is the default
assignment, but not mandatory.) Use shielded wiring, terminated at each end to chassis ground.
Contact Heads Up Technologies at
for information on the
HeadsUp XMD076
Broadcast Datalink Receiver,
contact Avidyne for information on the MLB700 Multilink Broadcast
Receiver.
4.7.4 ORBCOMM Datalink Antenna
For MFDs with internal ORBCOMM Datalink transceivers, see the wiring diagram in Appendix K:
Wiring Diagram – Lightning, Datalink Sensors, and ORBCOMM Antenna
. Connect MFD J2 with an
approved ORBCOMM Datalink antenna using RG-400U double-shielded coax cable MFD as shown.
Contact
for a broad selection of ORBCOMM antennas and multi-system antennas.
4.7.5 Iridium Datalink Antenna
For information on MLX770 installation, refer to the
MLX770 Datalink Transceiver Installation Manual
(600-00204-000).
4.7.6 Lightning Sensor Wiring
See the wiring diagram in Appendix K:
Wiring Diagram – Lightning, Datalink Sensors, and ORBCOMM
and the
WX-500 Installation Manual
or
TWX-670 Installation Manual
. Connect the RS-232
port of the lightning sensor to any of the available RS-232 ports of the MFD as shown. Use shielded
wiring, terminated at each end to chassis ground. Connect the lightning sensor jumpers for correct
stabilization source and antenna position. These settings will be also be set in the MFD and must
agree.
!
Caution:
It is extremely important that you perform noise mapping and ensure that the
proper grounds have been installed and checked after the Lightning interface is
installed. Ensure that the lightning sensor is installed and set up according to its
installation instructions. Excessive noise can produce erroneous lightning strike
indications.
Summary of Contents for 700-00004 Series
