Replacing the MTS
6
2
Using a 2.5mm Hex driver, remove the 8 fasteners that secure the back edge of the back cover to the S6L-24C chassis and set
the screws aside.
3
After removing the fasteners try sliding the back cover off the chassis by pushing it down with your hands and simultaneously
pulling the cover away from the chassis.
4
Slide the panel away from the control surface, and set the panel aside.
5
Using a 2.5mm Hex driver, remove the 4 fasteners that secure the top cover to the control surface.
6
Set a large towel or similar across the upper modules of the control surface (CKM, MTS, MLM) to protect them.
7
Carefully lift the top cover off the chassis and set it face down on the towel you placed on the surface, being careful to not stretch
or stress the cables connected to the light sockets.
8
.
Figure 6. Back Cover fasteners on S6L-24C
Figure 7. Top cover fasteners on S6L-24C (above, with End Cap loosened)
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver
