Replacing the MTS
4
2
After removing the fasteners try sliding the back cover off the chassis by pushing it down with your hands and simultaneously
pulling the cover away from the chassis. If the cover does not slide freely, do the following:
• Try inserting a small flathead screwdriver along its upper edge as shown in
and try to work one side free and then
the other.
• To be able to remove the back cover without risking scratching the chassis, first remove both end caps. (At minimum, one End
Cap needs to be loosened enough to let you remove the top cover later in these instructions. If you remove either (or both) of
the End Caps completely, carefully disconnect the LED power cable before moving the cap(s) away from the chassis.)
• Next, use a #2 Phillips screwdriver and remove one of the small retaining brackets.
3
Slide the panel away from the control surface, and set the panel aside.
Figure 2. End Cap and fasteners
Figure 3. Retention bracket and fasteners
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver
Fasteners:
Tool:
M3x6mm Phillips
#2 Phillips screwdriver
