Avid Technology VENUE S6L, Quick Start Manual, Page: 5 / 11

Replacing the MTS 5
4
Using a 2.5mm Hex driver, remove the upper back cover by removing its fasteners and then lifting the cover away.
• S6L-24D uses 13 fasteners
• S6L-32D uses 16 fasteners
• S6L-48D uses 22 fasteners
5
Proceed to
Remove the MTS
.
C-Series
To remove the covers from S6L-24C:
1
Using a 2.5 mm Hex driver, loosen or remove both the right and left End Caps by loosening the 7 fasteners securing the caps to
the chassis.
At minimum, one End Cap needs to be loosened enough to let you remove the top cover later in these instructions. If you remove
either (or both) of the End Caps completely, carefully disconnect the LED power cable before moving the cap away from the
chassis.
Figure 4. Removing the upper back cover (S6L-32D shown)
Figure 5. End Cap fasteners
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver