Replacing the MTS
7
Disconnect Light Cables
(S6L-24C Only)
Before removing the SBC tray you must label and disconnect the two Light cables connected to the Top Panel.
To disconnect the Light cables:
1
On S6L-24C disconnect the cables at the connectors shown below, then set the front panel aside.
2
.
Remove the MTS
The MTS must first be freed from the chassis and set face down on the control surface to allow access to the LVDS and other cables.
To remove the MTS:
1
Set a towel, blanket, or other padded material on top of the modules below the MTS.
2
Using a 2.5 mm hex driver, remove all fasteners securing the MTS to the chassis. Original units had 8 fasteners, later units 6.
Figure 8. Light cables (rear view of S6L-24C shown)
Figure 9. Fasteners that secure the MTS (front view shown)
