MLN-192 Option Card Installation
14
3
Replace the two screws to secure the top of the new bracket to
the tabs on the chassis.
Replace the Option Card Bracket
To replace the option card bracket:
1
Using a #2 Phillips screwdriver, loosen the two captive thumb-
screws that secure the bracket to the chassis.
2
Remove the old bracket and set it aside (it can be discarded).
3
Return to “Install the MLN-192 Card” on page 4 to install the
MLN-192 card. After the card is installed you will secure it by
installing the new Option Card bracket (instructions also pro-
vided below).
To install the new Option Card bracket:
1
After the card has been installed, position the new bracket as
shown, with its two slots facing inward and its single slot fac-
ing outward, and align its captive thumbscrews with their
threaded receivers on the chassis.
(The new Option Card bracket is reversible to allow for future
E6L option card development.)
2
Using a #2 Phillips screwdriver, tighten the thumbscrews to
secure the new bracket.
3
Return to “Install the MLN-192 Card” on page 4 and complete
the installation instructions.
Figure 58. Removing the original Option Card bracket
Figure 59. Installing the new Option Card bracket