PT
HD SDI Megapixel PTZ Dome Camera Instruction Manual
16/72
Installation with Wall Mount Bracket
①
Make a hole whose diameter is 30~40mm on
the mounting surface to pass the wire(s) and
cable(s) through the mounting surface. (In
case of the wiring and cabling through the
mounting surface only) Then prepare the wall
mount bracket. Pull the wire(s) and cable(s) for
the system as below. Attach the wall mount
bracket to the mounting surface. (Hex Lag
#14
50)
②
Hook up Drop Prevention Spring on main
body to prevent camera from unexpected
drop and pull the wire(s) and cable(s) for the
system as below.
Spring Wire Hook
③
Line up the mold lines and assemble main
body to mount adaptor and turn it. And
assemble the main both with the camera
mount adaptor with the 3 screws. (
TORX SCREW
M4
18
).
END
START
④
Screw the dome cover to the main body and
remove the protection vinyl from the dome
cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
INSTALLATION
2