PT
HD SDI Megapixel PTZ Dome Camera Instruction Manual
15/72
Installation with Ceiling Mount Bracket
①
Remove the ceiling tile from the ceiling and
cut a hole whose diameter is 30~40mm on the
ceiling tile to pass the wire(s) and cable(s)
through to the upside of the ceiling. (In case of
the wiring and cabling through the mounting
surface only) Then prepare the ceiling mount
bracket. Pull the wire(s) for the system as
below. (Anchor Bolt 3/8"
70)
②
Hook up Drop Prevention Spring on main
body to prevent camera from unexpected
drop and pull the wire(s) and cable(s) for the
system as below.
Spring Wire Hook
③
Line up the mold lines and assemble main
body to mount adaptor and turn it. And
assemble the main both with the camera
mount adaptor with the 3 screws. (
TORX SCREW
M4
18
).
END
START
④
Screw the dome cover to the main body and
remove the protection vinyl from the dome
cover.
Important Notice
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
To adjust the installation height from the mounting surface, the pipe and coupler should be needed between the
surface mount part of the ceiling mount bracket and the camera mount part of the ceiling mount bracket. Note that
they are not supplied by the manufacturer.
INSTALLATION
2