AVG-UHMS44
2. Force Carrier
a. Only if the IR receiver connected to HDBaseT receiver has an IR carrier, can
the received IR signal be transferred to the IR OUT port of the matrix.
b. Only if the IR receiver connected to the
IR
ALL IN
port of the matrix has IR
carrier, can the received IR signal be transferred to the IR OUT port of the
matrix.
If the IR receiver connected with HDBaseT receiver or IR ALL IN port of the
matrix is not with IR carrier, send the command “%0901.” to enter infrared
carrier enforcing mode, and then IR signal can be transferred to IR OUT port.
3. IR control setting
Controlling a far-end output device from local point
Connect an IR receiver with IR carrier to the IR IN port of AVG-UHMS44,
users can control far-end output displayer via its IR remote from local.
In that case, the IR signal is transferred via twisted pair. Only the
corresponding IR OUT port can emit control signals to the remote display.
See the figure below:
Control far-end device from local
Note:
The IR receiver connected to
IR IN
must have an IR carrier.
The IR signal received from IR ALL IN port will be transmitted to all the 4 far-
end HDBaseT receivers connected to HDBaseT ports of the AVG-UHMS44.
See as below:
Summary of Contents for AVG-UHMS44
Page 34: ...AVG UHMS44 7 Panel Drawing ...
