AVG-UDATP4
The interface of the control software is shown below:
Please set the parameters of COM number, baud rate, data bit, stop bit and the
parity bit correctly, only then will you be able to send commands in the Command
Sending Area.
Command format: ID +Port RS232 command.
Of which port number stands for the HDBT port that the device to be controlled
is connected to, the value varies from 1~4.
For example, if the ID of the AVG-UDATP4 is 01, and the device to be controlled is
connected to HDBT port 2, then send the command “1B1.” as “0121B1.”.
Note: To control AVG-UDATP4 via RS232 port, the communication protocol
parameters should be configured in the right manner: Baud rate: 9600; Data bit: 8;
Stop bit: 1; Parity bit: none.
5.2.3. Control a far-end device locally
Connect the RS232 ports of the AVG-UDATP4 and AVG-HD402PR (See Figure
Below), then it is able to control the AVG-UDATP4 and far-end device from local
position by sending RS232 commands.
Parameter
Configuration area
Monitoring area,
indicates whether
the command sent
works.
Command Sending
area
Summary of Contents for AVG-UDATP4
Page 20: ...AVG UDATP4 7 Panel Drawing ...
