AVG-CSK4K-44
2. EDID invoking:
There are five types of embedded EDID data. The chart below illustrates the detailed
information of the embedded EDID data:
No. EDID Data
1
1080P 2D 2CH
2
1080P 3D 2CH
3
1080P 2D Multichannel
4
1080P 3D Multichannel
5
3840x2160 2D
（
30Hz
）
Press and hold “EDID” for
3 seconds to enter EDID invoke mode. In this mode, use
the output buttons 1 & 2 to select the required embedded EDID data. Then press
“ENTER” to confirm
.
Format: Pr
ess and hold “EDID”
button for 3 seconds, INPUT# +OUTPUT1/2 +
ENTER.
Invoke embedded EDID data for one input:
Example: set the EDID data of input 2 to the fourth type of embedded EDID data
→
Press EDID (hold for 3 seconds to enter into EDID set status) + INPUTS 2 +
OUTPUTS1 or 2 + ENTER
5.1.2.3 Clear Operation
When you switch an output channel, learn EDID data, or set EDID data, press the
“Clear” button to EXIT the operation before you press “ENTER” to
finish. When you
press “Clear”
, the Matrix Switcher will return to its previous state.
5.1.3 Force Carrier
a)
Only if the IR receiver connected to the HDBaseT receiver has an IR carrier, can
the received IR signal be transferred to the IR OUT port of the Matrix Switcher.
b)
Only if the IR receiver connected to the Matrix Switcher has an IR carrier, can
the received IR signal be transferred to the IR OUT port of the Matrix Switcher.
If the IR receiver connected to HDBaseT receiver or the Matrix Switcher is
without an IR carrier signal, send the RS232
command “%0901.” to enter
infrared
carrier enforcing mode, and then the IR signal will be enabled to the IR OUT
ports.
