Avery Weigh-Tronix WI-125 SST, Service Manual

Page: 30 / 52

30
WI-125 SST Indicator Service Manual
The test mode is used to test various functions of the WI-125. The test
menu is shown in Figure 4. Instructions for using the test menu are found
below.
Figure 4
Test Menu
Press MENU to move Æ in the diagram
Press and hold MENU for 1.5 seconds to move Å in the diagram
Press PRINT/SELECT to move È in the diagram
Press PRINT/SELECT for 1.5 seconds to select new choice and move Ç in
the diagram
Press G/N at any time to save changes and return to gross/net weighing
mode
1. Enter the test mode from gross/net operation by pressing and holding
the MENU key until tESt is displayed. SEALEd or unSEALEd is dis-
played briefly while you hold the key. If you release the MENU key too
soon, press G/N to return to normal weigh mode and begin again.
2. Move to the right through the menu selections by pressing MENU
briefly. Move to the left through the menu selections by pressing MENU
for 1.5 seconds or hold down for continuous scrolling.
Indicator Diagnostics
Test Mode