Avery Dennison M09416 XLI, Service Manual

Page: 50 / 55

M09416
®
XLI
®
Thermal Direct Printer
47
A. Is label installed correctly? Please refer to previous 4. The LED is on red
blinking – Label runs out to load a roll of label and then press the FEED
button to resume printing.
B. Is there any label stuck on the label sensor? Is there any pre-printed logo on
the label? Please refer to 5.3 Printer Initialization to reset the system.
If the pre-printed logo or text influences the auto gap calibration function, please
calibrate the gap sensor with proper sensitivity setting by try and error method.
Example:
C:\>COPY CON LPT1 <Enter>
SET GAP 1 <Ctrl> <Z>
Main board, gap sensor or black sensor failure.
If you confirm the main board is good, Please change the gap sensor receiver
first, because the receiver sensor failure rate is higher then the transmitter
sensor.
4. The printer setting runs error .
Printer setting runs error:
Refer to 5.3 Initialization to reset the system.
5. Continuous feeding labels
The printer setting may go wrong. Please do “Printer Initialization” and “Gap
and Black Mark Sensor Calibration”. (Refer to 5.2 and 5.3).
6. No print on the label
Is the thermal head connector connected?
Is the thermal head broken? Check it by printer self-test printout.
Is main PCB U14, U15, Q1 or Q2 broken?
7. Printer does not print.
Printed by enclosed BarTender
This may be driver conflict problem. Please remove all the drivers in the
printer folder and then re-install the driver for your printer.
Printed by printer command (other error).
This problem is caused by incorrect syntax commands. This printer will ignore
incorrect syntax commands. Please set the printer to the dump mode and
make sure the printed command is identical to the commands sent from the