AVERATEC AV3360-EG1, User Manual

Page: 56 / 63

Appendix A
Q: Because of a software problem, I was unable to shut down
power normally. I pressed the power button to force a power
off, but it didn't work. How can I force a power off?
A: Make sure you press the power button for at least 4 seconds.
Normally, this will force a power off.
Q: Why can’t I charge the battery of my portable computer after it
was out of use for some time?
A: After portable computers have not been used for a long time (more
than one month), the batteries will go into the low voltage protection
mode due to data back-ups and natural electrical discharge. At that
point, restoring normal voltage will require slow charging over a
period of several hours. Calibration can be performed after the
battery has returned to a normal condition.
Q: My computer alerts “CMOS Battery Low”, what can I do?
A: If you keep your computer in no power situation (unplug the
computer from the power outlet and remove battery at the same)
over 45 days, your data in CMOS will be lost.
Please reconfigure your CMOS by following steps:
1. Press F1 to enter the BIOS setup utility.
2. Select “Load Optional Defaults?” . When you see the
following prompt, choose <OK> and then press <Enter>.
Load Optional Defaults ?
[OK] [Cancel]
3. Select
“Save Changes and Exit”. When you see the following
prompt, choose <OK> and then press <Enter> to restart your
computer.
Save configuration changes and exit setup?
[OK] [Cancel]