AVERATEC AV3360-EG1, User Manual

Page: 53 / 63

Using the BIOS Setup Utility
Change User Password
With a User password, you can enter the Setup Utility and change or
remove the User password, but you cannot enter the Setup Utility and
change or remove the Supervisor password, nor enable diskette access if
it has been disabled.
Change Supervisor Password
A supervisor password must be set before a lower-level user password
can be set. After selecting
Change Supervisor Password , press Enter .
You will be prompted for the new password, and then again to verify it.
Type in 6 or fewer keystrokes. If you make an error, press
Esc to start
over.
Resetting the CMOS to Default Settings
The main page provides the system parameters for you to reset the
CMOS to default settings. After you enter this page, select the Load
Optimal Defaults:
Select [OK] to reset the CMOS to default settings.
Exiting and Saving
Save Settings
and Exit
Select this option to save changes to the field
values, and restart the computer using the new
values. (Pressing F10 from any of the menu
screens also allows you to save settings and exit.)
Exit Without
Saving
Select this option to discard any changes you have
made to the field values, and restart the computer
using the old values.
Load Optimal Defaults?
[OK] [Cancel]